← All questions

How do I replay a route?

Updated 2026-11-19

Replay flies a saved route again on the map, from the start to the finish. You use it to look over a route before you go or to revisit one you have done. Replay is not the same as following a route, which guides you along the route while you are out on it.

Play a route

  1. Select a route.
  2. Click or tap the play button at the left of the scrubber, the slider under the map. Its tooltip reads Play route.
  3. The map moves along the course. The scrubber, the position marker on the elevation profile and the map move together.
  4. Click or tap the button again to pause. Its tooltip then reads Pause playback.

If you press play at the end of the route, replay starts again from the beginning. Selecting a different route stops replay, rewinds it and sets the camera back to Bird's-eye.

Choose a camera

The camera button at the right of the scrubber changes how the map moves. Each press goes to the next mode:

Bird's-eye (map stays) The map stays where it is and only the marker moves along the route.
Heading-up (2D) The map follows the marker and turns so the direction of travel points up. It stays flat.
Drone flight (3D) The map follows the marker and tilts, so you look down the course as if you flew along it.

Changing the mode is not limited to playing. With replay stopped, the map moves to the new view at the scrubber position. Bird's-eye returns to the view you had before. TrailRunner remembers the mode for the next launch. Because selecting another route resets it to Bird's-eye, that is the mode it remembers after you have picked a route; a fresh install starts in Drone flight (3D).

Speed and position

Where it is available

Replay and following