Replay flies a saved route again on the map, from the start to the finish. You use it to look over a route before you
go or to revisit one you have done. Replay is not the same as following a route, which
guides you along the route while you are out on it.
Play a route
Select a route.
Click or tap the play button at the left of the scrubber, the slider under the map. Its tooltip reads
Play route.
The map moves along the course. The scrubber, the position marker on the elevation profile and the map move
together.
Click or tap the button again to pause. Its tooltip then reads Pause playback.
If you press play at the end of the route, replay starts again from the beginning. Selecting a different route
stops replay, rewinds it and sets the camera back to Bird's-eye.
Choose a camera
The camera button at the right of the scrubber changes how the map moves. Each press goes to the next mode:
Bird's-eye (map stays)
The map stays where it is and only the marker moves along the route.
Heading-up (2D)
The map follows the marker and turns so the direction of travel points up. It stays flat.
Drone flight (3D)
The map follows the marker and tilts, so you look down the course as if you flew along it.
Changing the mode is not limited to playing. With replay stopped, the map moves to the new view at the scrubber
position. Bird's-eye returns to the view you had before. TrailRunner remembers the mode for the next launch. Because selecting another route
resets it to Bird's-eye, that is the mode it remembers after you have picked a route; a fresh install starts in
Drone flight (3D).
Speed and position
There is no speed control. The pace depends on the route's activity, for example walking or cycling, and on its
length. A replay takes roughly 12 to 90 seconds, a little more with the ease-in. It slows down before turns and at the finish.
To jump to a point, drag the scrubber. The number at its left is the distance so far and the number at its right is
the length of the route.
Where it is available
Mac and iPad in landscape: the scrubber is in the card at the bottom of the map, under the elevation profile.
iPhone and iPad in portrait: the scrubber is in the elevation sheet. Drag the sheet up. At its lowest height the sheet
shows only the profile.
Replay and following
Replay runs by itself and works on Mac, iPad and iPhone. Following uses your location and works on iPhone only.
Following shows the next turn and the trail sign. Replay does not.
The camera modes are alike: following offers Map stays put, Map turns with me
and 3D view.